H Beam Vs I Beam Connecting Rods

H beam is a stronger design when bending stress is considered davis said.

H beam vs i beam connecting rods.

All rods use arp 2000 bolts it is designed for durability with a little more material around the bolt. Conversely h beam connecting rods are a little bit stiffer and rigid and that makes them ideal for higher horsepower higher torque applications where there is going to be more compressive forces again this comparison only holds true if your comparing rods with the same material finish and length. They are all 100 machined on all surfaces stress relieved and shotpeened. With an h beam rod you should look at the thickness of the blades.

This design makes these rods more rigid and able to handle compression forces. Ohio crank h beam rods. Consequently h beam connecting rods are often recommended for high torque motors that produce a lot of power at low rpm under 6 000 rpm. H beam connecting rods incorporate two large flat sides with a thin section in the middle.

Depending on the material you would want at least 900 inch of thickness in that area. H beam rods are more difficult to machine so they are often more expensive. The ohio crankshaft h beam connecting rod is by far our most popular rod.